A cat wall turns an empty wall into a route your cat can walk along. Good layouts are less about the number of pieces and more about spacing and fixing. Plan it on paper (or with painter's tape on the wall) before you drill.
Start with an entry and an exit
Every route needs a way up and a way down. Begin near a piece of furniture your cat already uses — a sofa back, a sideboard or a cat tree — and end at a destination: a shelf by a window, a hammock or a cube house.
Spacing between pieces
- Keep the steps comfortable. Many owners start with gaps of roughly 12–18 in vertically and horizontally and adjust after watching their cat use it.
- Ladder bridges span a gap themselves — our bridges are about 23.6 in (60 cm) long, so plan the two ends to sit at a sensible distance.
- Leave headroom above each shelf so your cat can sit up.
Fixing into the wall
- Use a stud finder and fix into wooden studs wherever you can.
- Where there is no stud, use wall anchors rated for the load and suited to your wall (drywall, plaster or masonry). The included screws are not a substitute for the right anchor.
- Check every piece by pulling on it firmly before letting your cat on, and re-check the fixings from time to time.
Which set to start with
- 3-piece set: shelf, bridge and post — a short route or an extension to a tree.
- 5-piece skyline set: three shelves and two bridges across a wall.
- 9-piece system: a full climbing wall with posts, a hammock and a cube house.
Renting? Ask your landlord before drilling, or start with a floor-to-ceiling tree, which needs no holes.